6V Feeder/Micro Camera Power Panel - Troubleshooting

Not sure if this is your device? This article is for the 6V Feeder/Micro Camera Power Panel (SKU/Product #: enter here). 
Double-check this info or click here to visit our "Identify My Device" page before you continue.

Troubleshooting

The 6V Feeder/Micro Camera Power Panel is designed to support compatible FieldNode Micro Series cameras. If you're experiencing power-related issues or difficulty validating power from the panel, follow the steps below to troubleshoot.

Issue: Power Validation

1. Confirm Compatibility:
   • This panel is only compatible with FieldNode Micro Series cameras that use 4 AA batteries (6V).
   • It is not compatible with cameras that require 8 AA batteries (12V).
2. Check Battery Type:
   • Do not use rechargeable AA batteries — the panel is not designed to charge them.
   • Use only Energizer or FieldNode-branded AA batteries.
   • When the panel is depleted, the internal AA batteries will act as backup power.
3. Check Panel Charge Status:
   • Press the battery level indicator button on the panel.
   • If no lights come on, charge the panel fully using a USB to micro-USB cord and a different wall outlet.
   • Wait until the Charge Indicator LED is green before reconnecting.
   • If lights do come on, continue troubleshooting.
4. Replace Internal Batteries (if needed):
   • Swap out the current AA batteries with a fresh set of Energizer or FieldNode-branded batteries.
   • Reconnect the panel and monitor for further issues.

 Issue: No Power

1. Charge the Panel Fully:
   • Use a USB to micro-USB cord, charging block, and a different wall outlet than you normally use.
   • Charge until the Charge Indicator LED turns green.
2. Reconnect and Test:
   • Once fully charged, reinsert the panel into the camera securely.
   • Monitor for any further power issues.