Search

Rechargeable Battery Pack - Setup & Use

Thomas Hunt
Thomas Hunt

Not sure if this is your device? This article is for the Rechargeable Battery Pack (SKU/Product #: MMA-14109).
Double-check this info or click here to visit our "Identify My Device" page before you continue.

 

Getting Started

Congratulations! Now that you have your Rechargeable Battery Pack, continue reading to learn how to get it up and running!

23MM_RCHRG-BATT – 2c.png

 

  1. Charge battery pack to full capacity using included USB-C charging cable.
    Note: Charge time ranges from 4–14 hours depending on charger type. 6 hours is typical.
    1.  
    2. When plugged in, LEDs will light up for 5 seconds to indicate charge level. Solid LEDs represent a completed charge level. A flashing LED indicates current charge level.
      Example: If pack is at 27% when plugged in, the 1st LED will be solid and the 2nd LED will flash.
    3. Battery pack can be charged on its own or while installed in camera. Refer to charge level indicator on battery pack for most accurate reading.
  2. Insert battery pack into camera with indicator arrows pointing forward. Power camera ON.
    1. Battery pack should insert easily when oriented properly.
      See label example above.

  3. Open FieldNode Mobile app and set correct power source. Tap DEVICE > select your camera from device list > tap SETTINGS > tap POWER SOURCE > set to RECHARGEABLE PACK.

    CHECK BATTERY BUTTON: Press at any time to see charge level. LEDs will light up for 5 seconds.

Was this article helpful?

Comments

0 comments

Article is closed for comments.