Econo Plus Series - Setup & Use

Not sure if this is your device? This article is for the Econo Plus feeder kit (SKU/Product #: MFG-13054). 
Double-check this info or click here to visit our "Identify My Device" page before you continue.

Note: This article is for the setup of the feeder kit itself, not the hopper assembly. For hopper assembly instructions, go back a section & select our Hopper Setup section.

Getting Started

Congratulations! Now that you have your Econo Plus feeder kit, continue reading to learn how to get it up and running! 

1 INSTALL BATTERY:
Open Kit by removing wingnut located on the bottom and remove outer case. Install a 6-Volt Alkaline (ex. Energizer™) or FieldNode rechargeable battery by attaching the Red Alligator Clip to the positive terminal (+) and the Black Alligator Clip to the negative (-) terminal.

2 SWITCH PANEL:
Locate the Switch Panel inside Feeder.

3 SET FEED TIMES:
FieldNode Photocell Timers feed two times a day, one time after day break and again in the evening. The evening feed time is modifiable from 30 minutes before dark or just before dark as shown to the right.

4 SET RUN DURATION:
Slide Switches to desired Run Time as shown in the chart to the right.

Note: Feed amounts are approximate and may vary.

5 TEST FEEDER:
Press and release the small button located on the circuit board. GET AWAY FROM FEEDER AFTER PRESSING TEST BUTTON. The feeder will run one test cycle three seconds after test button has been pressed.