Gravity Series - Setup & Use

Not sure if this is your device? This article is for Gravity feeder kits (SKU/Product #: skus below). 
Double-check this info or click here to visit our "Identify My Device" page before you continue.

Getting Started

Congratulations! Now that you have your Gravity feeder kit, continue reading to learn how to get it up and running!

Block Feeder - SKU MFG-15118

Dual Capacity: Holds two (2) 9” x 9” x 9” mineral or protein blocks. Important: Using salt-based feeds or blends can cause corrosion and rust on parts of the feeder kit.

Feed Bin - SKU MFG-13338

Feed Bin - SKU MFG-15068

1. Wrap included strap through slotted holes on the back of the Feed Bin and around the tree Tighten strap by pulling loose end through buckle until Feed Bin is snug against the tree Fill Feed Bin prior to securing the lid Note: Don't fill the Feed Bin until properly secured to the tree.

Bag Feeder - SKU MFG-15019

1. Attach lower strap with the bottom of the feeder approximately 2' off the ground, then attach upper strap
2. Fill feeder to desired capacity
3. Roll the fabric closed and fold to secure; memory wire keeps the top closed

Feed Station II - SKU MFG-15009

1. Attach Feed Station II to tree while empty
2. Wrap strap through strap loops on back of Feed Station II and around tree
3. Tighten strap by pulling loose end through buckle until Feed Station II is snug against tree
4. Fill Feed Station II and attach lid by twisting clockwise